1. Volume: 50L, 100L, 200L, 300L, 500L, 600L, 1000L ~ 5000L.
2. Heating method: the heating rod is inserted into the jacket, and the non-cold zone is heated evenly.
Heat transfer oil or water is used to heat the material in the jacket and heat the material in the tank.
3, material heating temperature: 350 ℃ or less;
Material heating time: 20min ~ 90min (depending on process requirement).
4, temperature control: adopt electric measuring temperature and temperature controller connected to measurement and control temperature (temperature difference + / - 1 ° C or less), and can regulate the temperature of a material of high and low.
The temperature controller is installed in the electric control box, and the temperature transmission rod is inserted into the bottom of the tank, which can be used to indicate the temperature.
5. Batch tank body: surface mirror polishing process, roughness Ra is less than 0.4 mu m.
6. Upper cover: for two open type movable covers, easy to clean, the interior and exterior surface finish polishing treatment (roughness Ra is less than 0.4 mu m).
7, the inner pot bottom structure: by the spinning processing into R Angle, and the tanks after welding, polishing, no dead Angle, and a 5 ° inclined towards discharging mouth, easy to put the net material not stranded.
8. Clamping form: full jacket, used for heating oil or water to achieve optimal heating and cooling for work.
9. Thermal insulation: it adopts the pouring of pearl cotton, rock wool or polyurethane, and keeps the temperature difference with the outside world to achieve thermal insulation effect.
10. Surface treatment of outer shell: mirror polishing or 2B primary color sublight or 2B matte finish.
11. Stirring device: stirring at the top center, the output shaft of the reducer and the stirring propeller shaft are connected with a live sleeve for easy dismantling and cleaning.
12. Stirring speed: 15 ~ 120r/min (set speed);
Paddle type: frame type, anchor type, blade type, turbine type, etc. (by process requirement).
13. Mixing tank configuration: electrical control box, temperature meter, material liquid import and export, medium import and export (import and discharge), air outlet (overflow hole), etc.
14. Material of ingredients: SUS304 or SUS316L for internal tank;
The jacket is q235-b or SUS304;
The outer protective shell is SUS304.
15. The process of opening hole and inner tank welding is used in the process of opening and inner canning, smooth and easy to clean and no dead Angle, and beautiful appearance.